To setup the RSC card in Sun Fire 280R, V480, V490, V880, V890 servers and redirect the server console from serial port to RSC console. Hi Does any one know if there is a command on solaris to check system serial number apart from banner on ok prompt. Sun Microsystems Sun Fire V890 Manual Online: Serial Port Connector Diagram, Serial Port Signals. Serial Port Signals Signal Descriptions Ending In 'A'.
Where,- /dev/ttySX: Linux serial port (e.g., /dev/ttyS0 [COM1] )
- baud_rate: Usually 300, 1200, 9600 or 19200. This affects transmission as well as receive speed.
- cs8 or cs7: Specify the transmission of eight (or seven) bits per byte.
- ixon or -ixon: Enables (or disables) software flow-control (CTRL-S/CTRL-Q) for sending data.
- ixoff or -ixoff: Enables (or disables) software flow-control for receiving data.
- istrip or -istrip: Clear (or keep) the eight bit in each received byte.
In this example, I'm connecting to my Soekris based embedded router using /dev/ttyS0 with 19200 baud rate and cs8:
$ screen /dev/ttyS0 19200,cs8